FAST U.S. SHIPPING & EASY RETURNS

Dragon Window Pet Door Double Flap - Replacement Flap

Installation Instructions

Installation icon Difficulty Easy
Installation icon Steps 05
Installation icon Time Required 0.5 Hours
Installation icon Sections 02
Installation icon Flags 01

Parts

  • 1 Main Inner Flap - Interior piece with the Dragon logo
  • 1 Outer Flap - Exterior piece shaped like the letter “U”
  • 5 Thread-Forming Screws - ½” long screws
  • 4 Frame Strike Plates - ½” x 1 ¾” steel plates with adhesive backing

Tools

  • Phillips Head Screwdriver

Replacing the Flap

Step 1 Remove the Outer Flap

  • Remove the two screws holding in the U-shaped outer flap from the frame with a Phillips-head screwdriver.
  • If the screw head gets damaged, you can replace it with a new screw from the kit later.
  • Remove the old U-shaped flap. Discard damaged screws as needed.

Step 2 Remove the Inner Flap

  • Remove the three screws holding the main inner flap.
  • Remove the main inner flap from the frame.

Step 3 Remove the Old Magnets

  • Separate the magnets from the old flaps.
  • The magnets can be discarded in the trash.
  • The flap is recyclable. Contact your local waste management and ask if they can recycle polyolefin elastomers or flexible polyethylene.

Step 4 Install the New Inner Flap

  • Install the main inner flap onto the frame with the three center screws. The logo should face you, away from the frame.
  • Take care not to overtighten. Tighten just enough for the screw, the flap, and the frame to all be flush with each other. The flap material will start to deform if over tightened.

Step 5 Install the New Outer Flap

  • Install the U-shaped outer flap onto the frame with the two remaining screws.
  • The magnets should face towards the main flap and the frame.
  • The corners of the breakaway channel around the screw will bend outwards when overtightening begins.
  • If the flaps don't sit quite right, you can try massaging them into place.